Tuesday 14 December 2021

Jungle Cuisine, Explorer Broth - Scratch Building an Explorer in a Cooking Pot!

The final preparation work for the Land of the Lost game is done. The scenario needed one more specialty plot piece that required scratch building, 'the lost explorer in a Native Cooking Pot! Surprisingly I couldn't find a commercial one available but I don't mind pottering (pun haha) around anyway and putting something together myself. Here's the result...

Anyone for Wayward White Explorer Broth?

Explorer Broth ingredients;
Milliput
Wire
Twigs
Sheet styrene
An old figure, preferably with a sun helmet

Again I just created this on the go so here's the steps I followed!

1. Mix up a large blob of Milliput.
2. Roll most of this blob it into a ball, then elongate the ball rolling it so you get a cylinder with rounded ends, flatten one end, this will bulge that end and this will be the bottom of the pot, put your thumb into the other end and with a wet finger slowly work a lip between your thumb and finger, once flared and thinned and it looks like the top of a cooking pot smooth the surfaces and set aside.
3. Cut about a 35mm piece of sheet styrene and with the rest of the Milliput create a donut bigger than the pot diameter, flatten it and then add broken twigs to it to represent fire logs.
4. Push the cooking pot carefully onto the bases 'logs' to form an indent in it so it will sit level on the base later.
5. Form a piece of wire into a handle, at each end bend the wire at right angles and press into the cooking pot, let the pot set a bit first so you don't deform it. You could let it dry completely and drill small holes for the wire to fit into, I did it while it was still soft to save drilling.
6. When dry glue the cooking pot to the base and paint as desired.
7. Create a torso to fit in the cooking pot. I used a Warlord German Tank Commander and cut the head off as a base for the explorer, I then added a sun helmeted head left over from an Empress Miniatures vehicle. Add paint as desired!
8. When the cooking pot and figure are dry pour superglue into the cooking pot creating a pool and fit the torso into the centre of the 'puddle', I would recommend test fitting the torso and get it set up right to be level before pouring the superglue! There you're done!

This is the only 'in progress picture' I took, this is the end of step 6 above...

Dr Livingston on the boil!

A view from above, the liquid effect was simply done by creating a puddle...okay pool as it sounds cooler of superglue and then plunging Dr Livingston's torso into it!

Dr Livingston 'in the pot' and 'saved by the explorers'...hmmm not an exact match as he's grown a moustache to twirl out of the pot! Never fear dear reader it won't matter on the night!

Next Time; Most probably the land of the Lost AAR!

10 comments:

  1. Dry nicely done…Im tempted to make one even though I’m not sure I will ever need him 😀

    ReplyDelete
    Replies
    1. Cheers Matt...come on you know you need an 'explorer in a cooking pot' in 1/56
      😉

      Delete
  2. Fun little model to have & you pulled it off with a plumb 👏😊

    ReplyDelete
  3. Very nice and unusual game marker.

    ReplyDelete
  4. Looks like he's in a spot of bother... great work and a good walk through.
    Cheers
    Stu

    ReplyDelete
    Replies
    1. Cheers Stu, yes I’d say ‘He’s in a bit of a pickle!’.

      Delete